There seem to be 3 things you can program using the remote:
- Alarm Arm Beep signal (Confirmation alarm tone after activation/deactivation in addition to indicators lighting up) : Active, Not Active
- Alarm Siren Sound (Rising and Falling or Intermittent Alarm tone) : ECE, US
- Alarm Automatic Arming (when ignition is switched off) : Active, Not Active
The process to programme these is as follows:
- Deactivate alarm function.
- Switch on ignition.
- Press button 1 three times.
>> Acknowledgment tone sounds once.
- Switch off the ignition within ten seconds.
- Press button 2 three times.
>> Acknowledgment tone sounds once.
- Switch on the ignition within ten seconds.
>> Acknowledgment tone sounds three times.
- The programming function is active.
The actual programming is carried out in 4 steps, and Step 2 is not assigned any function.
The number of flashing signals on the DWA indicator lamp of the motorcycle shows the active programming step. Pressing the button 1 is confirmed by an alarm tone, and pressing the button 2 by an acknowledgment tone.
Step 1:
is a confirmation tone to sound after the DWA is activated/deactivated?
Yes: -> Press button 1.
No: -> Press button 2.
Step 2:
This step is not assigned any function.
-> Press button 1 or button 2.
Step 3:
Which alarm tone is to be selected?
Rising and falling: -> Press button 1.
Intermittent: -> Press button 2.
Step 4:
Is the alarm function to be automatically activated after the ignition is switched off?
Yes: -> Press button 1.
No: -> Press button 2.
When is the programming canceled?
Programming is canceled by :
- switching off the ignition before the last programming step.
- or automatically if more than 30 seconds pass between 2 programming steps.
The data are not saved when programming is canceled.
Save programming
Programming is saved :
- by switching off the ignition after the last programming step.
- or automatically 30 seconds after the last programming step.
The DWA indicator lamp stops flashing and 4 acknowledgment tones sound.